自上料攪拌車需檢查一些“硬核”問題
自上料攪拌車的使用過程也不一定都很順利，尤其是您在駕駛工作前做好相應檢查的話，非常容易就會出現各種樣式的問題故障，下面自上料攪拌車廠家來講講設備需檢查一些“硬核”問題。
The use process of the self feeding mixer is not always smooth, especially if you do a good job in the corresponding inspection before driving, it is very easy to have various types of problems and failures. Now let's talk about some "hard core" problems that need to be checked for the equipment from the manufacturer of the self feeding mixer.
1、控制氣壓緊固接頭.罐體內應該打進多少的氣壓，這個在出廠的時候已經設定好，不需自己調節。如果遇上特殊情況非要調節，建議壓力控制在3.5Mpa左右，壓力太大容易爆管。另外，新的自上料攪拌車以及日常使用中，要對管路接口的地方隨時緊固，防落。
1. Control air pressure fastening connector How much air pressure should be injected into the tank, which has been set at the factory, does not need to be adjusted. If it is necessary to adjust under special circumstances, it is recommended to control the pressure at about 3.5Mpa. If the pressure is too high, the pipe will burst easily. In addition, the new self feeding mixer truck and its daily use shall be fastened at any time at the pipe interface to prevent falling off.
2、罐車加水流程.每種罐車加水處的布置都大同小異，一般都是水罐排氣——加滿水——關閉加水閥;在不用的情況下，將撥桿的位置放在中間。
2. Water filling process of tank car The arrangement of water filling places of each type of tank car is much the same with little difference. Generally, the water tank exhausts - fills up the water - closes the water filling valve; When not in use, place the paddle in the middle.
3、冬季排盡管內余水.在冬季每天收車之后應該排盡水罐內和水管中的水，并在水管打入壓縮空氣吹盡各個管路中殘留的水，防止因為結冰造成管路凍裂。水泥自上料攪拌車
3. In winter, there is no water left inside In winter, the water in the water tank and water pipe shall be drained after the vehicle is collected every day, and compressed air shall be injected into the water pipe to blow away the residual water in each pipe, so as to prevent the pipe from freezing and cracking. Cement self loading mixer
4、隨車帶上減水劑，減水劑是一種在維持混凝土坍落度不變的條件下，能減少拌合用水量的混凝土外加劑，隨車攜帶，能對混凝土進行很好的調節。不過在加入減水劑的時候，一定要記得有商砼站化驗室的人在場，否則混凝土質量強度不夠，駕駛員要承擔后果。
4. The water reducing agent is a concrete additive that can reduce the mixing water consumption under the condition that the concrete slump remains unchanged. It is carried with the vehicle and can adjust the concrete well. However, when adding water reducing agent, be sure to remember that there are people in the laboratory of the commercial concrete station, otherwise the concrete quality and strength are not enough, and the driver will bear the consequences.
5、回廠檢查罐內水量.每次出車任務完成回到站內的時候，檢查儲水罐內的水量，讓水罐中的水隨時處于滿罐的狀態，以備不時之需。
5. Return to the factory to check the water volume in the tank When returning to the station after completing the task of driving, check the water volume in the water storage tank to keep the tank full at any time for emergency.
6、離廠前檢查混凝土質量。可能會因為原料的不同，每一盤混凝土質量都會有變化。在裝好混凝土離場時，一定要檢查罐內混凝土的塌落度情況以及和易度，小心混凝土的提前凝結和混凝土分層沉淀。
6. Check the concrete quality before leaving the factory. The quality of each plate of concrete may change due to different raw materials. When the concrete is loaded and leaving the site, it is necessary to check the slump and workability of the concrete in the tank, and be careful of the early setting and layered precipitation of the concrete.
7、減少車輛行駛時間.混凝土運距一般在直徑30范圍以內，出車之前規劃好路線以及車輛通行情況，盡量減少車輛在路上的時間。
7. Reduce vehicle travel time The transportation distance of concrete is generally within the range of 30km in diameter, and the route and traffic conditions of vehicles shall be planned before departure to minimize the time of vehicles on the road.
8、減少損失先卸料.如果遇到人為因素或者不可抗因素，導致長時間無法卸料的情況，應隨時查看罐內混凝土情況，一旦發現混凝土開始凝結。在報備負責人之后立刻進行卸料，以防整個罐體報廢。
8. Unload first to reduce losses In case of human factors or irresistible factors that make it impossible to unload materials for a long time, the concrete in the tank shall be checked at any time. Once it is found that the concrete starts to set. Unload immediately after reporting to the person in charge to prevent the whole tank from being scrapped.
9、隨時需清洗.運營當中隨時沖洗。在每次卸料之后，用罐車自己帶水槍對罐口、葉片、進料口、罐體以及犄角旮旯進行沖洗，防止混凝土凝固之后越積越多，不好清理。
9. Clean at any time Rinse at any time during operation. After each unloading, use the tanker with its own water gun to wash the tank mouth, blade, feed inlet, tank body and corners to prevent the concrete from accumulating more after solidification, which is difficult to clean.
要注意，收車之后清洗罐車。每天的運送任務結束之后，在罐內加入1立方米以上的清水，快速的旋轉罐體進行清洗。有條件的公司，還可以在罐內加入石子，效果會更好。更多使用注意事項就來我們網站http://www.jbckj.cn進行咨詢吧！
Please note that the tank car shall be cleaned after the car is collected. At the end of the daily delivery task, add more than 1 cubic meter of clean water into the tank and quickly rotate the tank for cleaning. If conditions permit, you can also add stones in the tank to achieve better results. More usage precautions come to our website http://www.jbckj.cn Consult!
